The Twist X fits any tablet that has a width between 220mm to 280mm and a height between 150mm to 205mm. The four fully adjustable rubberised arms hold your tablet in place for viewing at just about any angle. Once adjusted the arms are secured in place by a lever on the rear of the stand. Sliding the lever allows the arms to open for tablet removal.
The Twist X can rotate freely between portrait and landscape and can further be flipped front and back to show users on both sides of the stand.
Extra long charging cord. We also offer an extra long 10ft charging and sync cable for iPads. The cable can be purchased through this link - 10ft iPad Cable
The Twist X comes 100% pre-built and is ready to use straight out of the box.
The stand has two screw holes for permanent table fixing (Screws are not provided). Alternatively double sided tape could be used (Tape is not provided).
The Twist X is available in black only.
Twist X Enclosure
ABS Plastic and Metal
Maximum Tablet Height: 205mm to 150mm Maximum Tablet Width: 280mm to 220mm Including: iPad 2, 3 and 4. iPad Air 1 & 2. iPad Pro 9.7". Galaxy Tab 3 and 4. Galaxy Tab S 10.5. Galaxy Tab A 9.7". Galaxy Tab S2 9.7". Surface 3
Can I lock this stand using a key?
No. The Twist X is not a lockable stand. Anybody with access to the stand can remove the installed tablet.
Does the Twist X come pre assembled?
Yes. The Twist X enclosure is shipped ready to go, no installation is needed.
How do I install and remove my tablet?
To install the tablet in the Twist simply move the lever on the back of the stand to the 'release' setting, you will then be able to spread the Twist clamps wide enough to place your tablet inside, once you have done this, simply move the lever back to 'secure' and tighten the clamps.
To remove your tablet unlock the enclosure and move the lever to 'release'.
Can I mount it to a wall?
Yes you can, though we don't recommend it. The Twist X has been designed to be used solely as a table stand, but by using the provided screw holes it can be mounted to a wall.